• Rinse the preparation thoroughly and remove all visible water by drying the surface for approximately 5 seconds with dried compressed air. Do not desiccate the tooth surface.
• Apply Clean & Boost™ Gel to the enamel surfaces to be bonded. Allow material to dwell for 15 seconds, rinse thoroughly and leave moist.
• Dispense a drop of Superb Universal Bond into the cavity of the enclosed mixing well. Using an applicator bristle-type brush, apply 1 coat of Superb Universal Bond to the entire cavity preparation and the surrounding tooth structure, allow to dwell for 20 seconds. DO NOT DRY
• Using the remaining material in the well and same applicator, apply 2 additional coats of Superb Universal Bond.
• Dry the surface thoroughly. Do not blast the surface with air or use suction as this could remove material from the surface and lead to debonds or post operative sensitivity.
• Light-activate for ten seconds. Superb Universal Bond can be activated with any dental activation light.
• Continue restorative procedure with material of choice. Follow manufacturer’s instructions for all restorative materials.

NOTE: Deciduous teeth are treated in the same manner as permanent teeth.

NOTE: Uncut enamel should be roughened or etched prior to bonding.

NOTE: Superb Universal Adhesive is always light-activated before placing veneers and bonded crowns.