Apex Information Exchange Forum Index Apex Information Exchange
Hosted by Dr. John Kanca III DMD
 FAQFAQ   SearchSearch   UsergroupsUsergroups   REGISTER 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Visit Apex Dental Materials     Upload Photos To Your Post

Adhesion on collagen-depleted dentin

Post new topic   Reply to topic    Apex Information Exchange Forum Index -> Literature
View previous topic :: View next topic  
Author Message

Joined: 08 Jul 2009
Posts: 76

PostPosted: Wed Aug 05, 2009 8:49 am    Post subject: Adhesion on collagen-depleted dentin Reply with quote

J Adhes Dent. 2008 Dec;10(6):419-22.
Adhesion of a two-step etch-and-rinse adhesive on collagen-depleted dentin.
Saboia VP, Nato F, Mazzoni A, Orsini G, Putignano A, Giannini M, Breschi L.

Department of Restorative Dentistry, Federal University of Ceará, Fortaleza, Brazil.

PURPOSE: To evaluate microtensile bond strength and interfacial nanoleakage expression of adhesive interfaces created by XP-Bond on human deproteinized dentin immediately after bonding and after 6 months of artificial aging. MATERIALS AND METHODS: Noncarious human molars were selected, middle/deep dentin substrates were exposed, and either assigned to group 1 (XP-Bond applied on collagen-depleted dentin) or to group 2 (XP-Bond applied in accordance with manufacturers' instructions). In group 1, the etched dentin surface was treated with 10% NaOCl for 60 s to remove the exposed demineralized organic matrix before XP-Bond application. Composite/dentin beams were obtained in accordance with the microtensile nontrimming technique and either pulled to failure after 24 h or after 6 months' artificial aging. Data were analyzed with two-way ANOVA and Tukey's post-hoc test (p < 0.05). Interfacial nanoleakage evaluation was performed on additional adhesive interfaces to quantify the amount of silver tracer along the interface. RESULTS: The use of NaOCI before XP-Bond application (group 1: 18.9 +/- 5.8 MPa) reduced immediate bond strength by 62% compared to controls (group 2: 49.9 +/- 10.3 MPa; p < 0.5). After 6 months of artificial aging, the bond strength of groups 1 and 2 significantly decreased to 10.1 +/- 2.7 MPa and 35.2 +/- 8.7 MPa, resp (p < 0.05). Interfacial nanoleakage expression along XP-Bond adhesive interfaces was increased either by sodium hypochlorite or by artificial aging. CONCLUSION: The role of collagen fibrils is pivotal for the bonding of XP-Bond to dentin, as decreased immediate bond strength and reduced bond stability over time was found on collagen-depleted dentin.


Does it means that bonded cores after RCT is not a good idea ? Should we treat somewhat the surface prior to bonding ?
Back to top
View user's profile Send private message
john kanca

Joined: 14 May 2005
Posts: 6346

PostPosted: Fri Aug 07, 2009 4:50 pm    Post subject: Reply with quote

The short answer is use Surpass. I cannot go into too much detail because I am on a ship.
"You need me on that wall."

"You don't have a town named after you"
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Apex Information Exchange Forum Index -> Literature All times are GMT - 5 Hours
Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB © 2001, 2005 phpBB Group