Apex Information Exchange Forum Index Apex Information Exchange
Hosted by Dr. John Kanca III DMD
 
 FAQFAQ   SearchSearch   UsergroupsUsergroups   REGISTER 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Visit Apex Dental Materials     Upload Photos To Your Post


Etching decreases bond strengths of one bottle adhesives

 
Post new topic   Reply to topic    Apex Information Exchange Forum Index -> Literature
View previous topic :: View next topic  
Author Message
john kanca



Joined: 14 May 2005
Posts: 6346

PostPosted: Sun Dec 28, 2008 12:26 pm    Post subject: Etching decreases bond strengths of one bottle adhesives Reply with quote

Oper Dent. 2008 Nov-Dec;33(6):702-9.Links
Bonding durability of single-step adhesives to previously acid-etched dentin.Ikeda M, Tsubota K, Takamizawa T, Yoshida T, Miyazaki M, Platt JA.
Nihon University School of Dentistry, Department of Operative Dentistry, Tokyo, Japan.

This study investigated the effect of phosphoric acid etching on the dentin bond strength of five single-step self-etch adhesive systems; Absolute, Clearfil tri-S Bond, Fluoro Bond Shake One, G-Bond and One-Up Bond F Plus. Bovine mandibular incisors were mounted in self-curing resin and the facial surfaces were wet ground with #600 SiC paper. Adhesives were applied on the prepared dentin surfaces with and without prior phosphoric acid etching and light irradiated. Resin composite was condensed into a mold (°4x2 mm), light irradiated and stored in water at 37 degrees C. Four groups (n=10) were made per adhesive system: with and without prior acid etching and with and without thermal cycling between 5 degrees C and 55 degrees C for 10,000 cycles. The specimens were tested in a shear mode at a crosshead speed of 1.0 mm/minute. Two-way ANOVA, Student t-test and Tukey HSD test at a level of 0.05 were done. For specimens without prior acid etching, the mean bond strengths to bovine dentin ranged from 12.8 to 17.1 MPa and ranged from 6.7 to 13.3 MPa for specimens with prior acid etching after 24 hours storage in water. When the specimens were subjected to thermal cycling, the mean bond strengths ranged from 10.7 to 24.8 MPa for the specimens without prior acid etching and 4.6 to 13.9 MPa for the specimens with prior acid etching. The changes in dentin bond strength were different among the adhesive systems tested. Failure modes were commonly adhesive failure associated with mixed failure for specimens with prior acid etching. For specimens without prior acid etching, failures in composite and dentin were increased. From the results of this in vitro study, prior acid etching might be not acceptable for increasing the dentin bond strengths of single-step self-etch adhesive systems.
_________________
"You need me on that wall."


"You don't have a town named after you"
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Apex Information Exchange Forum Index -> Literature All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group