Instructions:

TITAN is a light-cured composite with flow characteristics that make it ideal for use as a liner in Class I and II restorations, pit and fissure sealants, repair of marginal defects, small core build-ups, porcelain repair, porcelain veneer cementation and bonding splints. Other uses for TITAN are Class V restorations as well as Class III and small Class IV’s.

TITAN is flowable; however it has been designed to not slump, which provides better control in hard-to-access areas. Using the tips provided, TITAN is easily injected directly into the cavity preparation. The material can be shaped with the provided dispensing tips.

• Optimal Handling

• Unsurpassed Strength and Toughness

• High Level of Radiopacity

• Ideal Aesthetics

PRINCIPAL USES OF TITAN

CAVITY LINER:

1. Isolate and prepare the tooth surface to be restored.

2. Apply an adhesive, such as the Simplicity® Self-Etch Adhesive System or Surpass Self-Etch Adhesive System, according to the manufacturer's instructions.

3. Using the appropriate shade of TITAN, place a 1 mm layer of TITAN onto the floor and walls of the cavity preparation. Light-cure the layer for 20 seconds.

4. Continue to build the restoration using the composite material of your choice. The composite material should be used according to the manufacturer’s instructions.

COMPOSITE FILLINGS:

1. Isolate and prepare the tooth surface to be restored.

2. Apply an adhesive, such as the Simplicity® Self-Etch Adhesive System or Surpass Self-Etch Adhesive System, according to the manufacturer's instructions.

3. Using the appropriate shade of TITAN, place a 1mm to 2 mm increment of TITAN into the cavity preparation. Light-cure for 20 seconds.

4. Continue to build the restoration incrementally until the cavity preparation is filled to the desired level. Light-cure each increment for 20 seconds

5. Shape and finish to desired level.

NOTES:

1. To prevent excess material from extruding out of the syringe, pull the plunger back immediately after the desired amount is dispensed.

2. TITAN can be light activated with LED, halogen or other conventional curing lights.

3. TITAN should be used with 18 or 20 gauge tips

4. TITAN White Opaque should be light activated for 40 seconds