|
Although it is not critical to
the success of SURPASS™, it is recommended that the preparation
be cleaned with isopropyl alcohol on a cotton pellet and rinsed
with water prior to beginning the bonding protocol. Pumicing or
gentle particle abrasion of enamel is also recommended.
-
Rinse the preparation
thoroughly and remove all visible water by drying the surface
for approximately 5 seconds with dried compressed air.
-
Dispense a drop of SURPASS™
1 into one cavity of the enclosed mixing well. Using the
proper color-coded brush, apply SURPASS™ 1 to the entire
cavity preparation and the surrounding tooth structure,
agitating briskly for at least ten seconds.
DO NOT DRY SURPASS™ 1
-
Dispense a drop of SURPASS™
2 into another cavity of the mixing well. Using the proper
color-coded brush apply three brushfuls of SURPASS™ 2 to the
entire cavity preparation, dabbing each brushful to help
distribute as much of the primer as possible.
-
Dry the primed surface with
dried compressed air for at least ten seconds with the air
syringe tip as close as possible to the surface.
DRY SURPASS™ 2
THOROUGHLY
-
Dispense a drop of SURPASS™
3 into another cavity of the mixing well. Using the proper
color-coded brush apply a thin layer of SURPASS™ 3 to the
entire cavity surface.
-
Light-activate for ten
seconds. SURPASS™ can be activated with any dental activation
light.
-
Continue restorative
procedure with material of choice. Follow manufacturer’s
instructions for all restorative materials.
NOTE: For indirect restorations, air-thin
SURPASS™ 3 sufficiently to allow seating of the restoration and
light-activate.
NOTE: Deciduous teeth are treated in the same manner as
permanent teeth.
NOTE: SURPASS™ 1 should be agitated for 15 seconds on uncut
enamel.
NOTE: SURPASS™ is always light-cured before placing veneers and
bonded crowns. |
