Interface Instructions

Delivery of Ceramic Inlays, Onlays, Crowns and Veneers

1. Using a Microtip^® applicator, apply an even coating of the prepared Interface solution to the ceramic surface and allow to dwell for 10 seconds.
2. Dry the Interface solution thoroughly (approximately 5 seconds).
   
   The ceramic surface has now been etched and silanated.
3. If using Simplicity:
   1. Apply 1 coat of Simplicity 2 to the dried Interface surface
   2. Dry thoroughly
   3. Light activate for 10 seconds
   4. Apply a final coat of Simplicity 2
   5. Dry thoroughly but do not light activate
   If using Surpass^®:
   1. Apply 2 coats of Surpass^® 2 and dry thoroughly
   2. Light activate for 10 seconds
   If using a different adhesive or self-etch cement follow manufacturer’s instructions
   
   

1. Clean any remaining temporary cement with a Microtip^® and Simplicity 1 or Surpass^® 1.  Either of these materials will dissolve the remaining cement.
2. Rinse and dry the prep.
3. If using Simplicity:
   1. Apply 1 coat of Simplicity 2 to the dried Interface surface
   2. Dry thoroughly
   3. Light activate for 10 seconds
   4. Apply a final coat of Simplicity 2
   5. Dry thoroughly but do not light activate
   If using Surpass^®:
   1. Apply 2 coats of Surpass^® 2 and dry thoroughly
   2. Light activate for 10 seconds
4. Place the resin luting material (such as Anchor^®) into the crown or onlay and insert.